Home > Case
Coal Briquetting Machine Finishes Commissioning In Tanzania

coal briquetting machine

Installation Location

Tanzania

Capacity

15tph

Working mode

Continuous(24h)

Model: TD650H
Capacity: 15tph 
Moisture: ≤7% 
Working position: Tanzania 
  First coal briquetting machine pressed the ball after natural drying, drying the coal dryer cylinder filled (about 30 tons each drying cylinder) ball, began to send hot air oven about hours, until the furnace temperature rose to about 200 degrees, starting from coal briquetting machine through the feed conveyor to the dryer, turn on the dryer while the lower end of the discharge gate began to emit a dry ball. Gate opens to the size of the feeding amount of coal briquetting machine feed rate commensurate. Observed the ball wet and dry conditions, if the result is not good appears dry, still wet bulb should increase the air volume, improve temperature, on the contrary, reduced air volume, reduce the oven temperature, until the results of the best as well.

 

Related Case

TD3.0 Model Coke Powder Briquetting Machine Works in Indonesia

TD3.0 Model Coke Powder Briquetting Machine Works in Indonesia

Capicility:3ton/h

Cycle:50(day)

Small Steel Slag Briquetting Plant Works Saudi Arabia

Small Steel Slag Briquetting Plant Works Saudi Arabia

Capicility:3ton/h

Cycle:50(day)

1TPH Wood Pellet Production Line Installed in Philippines

1TPH Wood Pellet Production Line Installed in Philippines

Capicility:3ton/h

Cycle:50(day)

TD3.0 Model Coke Powder Briquetting Machine Works in Indonesia

TD3.0 Model Coke Powder Briquetting Machine Works in Indonesia

Capicility:3ton/h

Cycle:50(day)

Small Steel Slag Briquetting Plant Works Saudi Arabia

Small Steel Slag Briquetting Plant Works Saudi Arabia

Capicility:3ton/h

Cycle:50(day)

Online Message

+86-371-86565118 0086-18539990967 service@tdaxy.com
High and New-Tech Industry Development Zone, Zhengzhou , Henan, China